Garmin 695 Manual De Usuario
Garmin GPSMAP 695/696 Owner’s Manual
190-00919-00 Rev. G
Appendix D
213
Overview
GPS Navigation
Flight Planning
Hazar
d A
voidance
voidance
Additional F
eatur
es
Appendices
Index
A
dvAnced
nmeA o
UtpUt
s
etUp
If interfacing the GPSMAP 695/696 with another piece of equipment (such as an
autopilot), the unit needs to be set to output NMEA data. If the NMEA output mode is
set to ‘Fast’, the unit will output a minimum number of NMEA sentences at 1-second
intervals. If the NMEA output is set to ‘Normal’, the unit will output a greater number
NMEA sentences as 2-second intervals.
set to ‘Fast’, the unit will output a minimum number of NMEA sentences at 1-second
intervals. If the NMEA output is set to ‘Normal’, the unit will output a greater number
NMEA sentences as 2-second intervals.
Setting NMEA output mode:
1) Press the MENU Key twice to select the Main Menu.
2) Turn or move the FMS Joystick to select ‘System Setup’, and press the ENT
2) Turn or move the FMS Joystick to select ‘System Setup’, and press the ENT
Key.
3) Turn or move the FMS Joystick to select ‘Interface’, and press the ENT Key.
4) With the ‘Serial Data Format’ field highlighted, turn the FMS Joystick to
4) With the ‘Serial Data Format’ field highlighted, turn the FMS Joystick to
select ‘NMEA In/Out’.
5) Move the FMS Joystick to highlight the ‘NMEA Output Mode’ field.
6) Turn the FMS Joystick to select ‘Normal’ or ‘Fast’.
6) Turn the FMS Joystick to select ‘Normal’ or ‘Fast’.
NMEA Sentence Output:
• Normal Mode: GPRMB, GPRMC, GPGGA, GPGSA, GPGSV, GPGLL, GPBWC,
GPVTG, GPXTE, GPBOD, GPRTE, GPWPL, GPAPB, PGRME, PGRMZ, PGRMM,
and PGRMH.
and PGRMH.
• Fast Mode: GPRMB, GPRMC, PGRMZ, and PGRMH.
CONNECTING TO A GTX 330 MODE S TRANSPONDER
To receive Mode S TIS-A traffic data from a GTX 330 transponder on your GPSMAP
695/696, connect an available RS-232 OUT pin on the transponder to the Data In pin
on the GPSMAP 695/696. (You do not need to connect the transponder to the GPSMAP
695/696’s Data Out pin.) Then, set the corresponding RS-232 output configuration on
the transponder to REMOTE + TIS-A and set the GPSMAP 695/696’s Serial Data Format
to GTX TIS-A In or GTX TIS-A In/NMEA & VHF Out (refer to the Interfacing section). For
more information, see Appendix E and the GTX 330 Transponder Installation Manual.
on the GPSMAP 695/696. (You do not need to connect the transponder to the GPSMAP
695/696’s Data Out pin.) Then, set the corresponding RS-232 output configuration on
the transponder to REMOTE + TIS-A and set the GPSMAP 695/696’s Serial Data Format
to GTX TIS-A In or GTX TIS-A In/NMEA & VHF Out (refer to the Interfacing section). For
more information, see Appendix E and the GTX 330 Transponder Installation Manual.