Graco 312497F Manual De Usuario

Steps 1-8, refer to F

1.

Install the new or replacement module to the sec-
ondary divider valve assembly. Also connect the 
tubing or hoses to the appropriate lubrication point if 
the new/replacement module is a base section. 

2.

Do not completely tighten the connection(s) at the 
lubrication point.

3.

Remove the performance indicator or indicator port 
plug from the working valve section on the second-
ary divider valve assembly corresponding to the out-
let port and line connected to a particular lube point.

4.

Attach a hand pump filled with clean, filtered lubri-
cant to the port on the secondary divider valve that 
was opened in Step 3.

5.

Operate the hand pump until air-free lubricant is 
observed flowing from the loosened connector at 
the lube point.

6.

Tighten the fitting at the lube point while lubricant is 
still flowing.

7.

Repeat Steps 3 - 6 for any additional lubrication 
points connected to the new module.

8.

Remove the hand pump and reinstall the perfor-
mance indicator or port plug removed in Step 3 into 
the secondary divider valve’s open port.

The system is now ready for operation.

TI11115

MASTER

HAND PUMP

BLEED HOSE

REMOVE INDICATOR
OR PORT PLUG

SECONDARY

LUBE POINT

HERE

NEW VALVE
BLOCK

BLEED
HERE