Furuno B042-008 Manual De Usuario

3. INITIAL SETTINGS 

Select navigator and heading sensor used as below. 
 
1.  Turn on the power and turn the [FUNCTION] switch to the MENU position. 
2. Press [

!

] and [+] to select SYSTEM at the top of the screen. 

3. Press [

"

] to select NAV DATA SETTING, and then press [+] to open that menu. (If a 

heading sensor is connected but not a navigator, go to step 18.) 

DISP  ALM  TX/RX  E/S  SYSTEM

Select speed unit.

[-/+]: Change set, [EXIT]: Exit

NAV DATA SETTING

:

SPEED INPUT

: SENSOR

SPEED ADJUST

: +0% (-50   +50)

SPEEDOUTPUT

: ON

SPEED INFO

: OFF

NMEA VERSION

: Ver 2.0

NAV DATA

: AUTO

COURSE

: TRUE

TLL OUTPUT

: OFF

4.  The cursor is selecting SPEED UNIT; press [+] or [-] to open the dialog box. 

km/h    MPH

5.  Use [-] or [+] to select the speed unit, and then press [

!

] or [

"

] to close the dialog box. 

6. Press [

"

] to select SPEED INPUT, and then press [+] or [-] to open the dialog box. 

  NMEA

7.  Use [+] or [-] to select the source of speed data, and then press the [

!

] or [

"

] to close 

the dialog box. 
SENSOR: Speed/temperature 

sensor 

NMEA: 

Speed data input from the equipment connected. 

8. Press [

"

] to select SPEED ADJUST, and the press [+] to open the dialog box. 

9.  You may offset speed data to further refine its accuracy. This is not possible when the 

speed input is “NMEA”. 

a) 

Watch the speed sensor readout on the monitor (if it is not displayed set SPEED INFO 
to ON) and compare it with known value. 

b) 

Use [+] or [-] to enter the difference found in a) above. For example, if the indication of 
the FCV-1100L is +5 % faster than the actual value, enter –5.