Cal Flame Barbecue Grills & Carts Manual De Usuario

2009 Barbecue Grills and Carts

LTR20091038, Rev. A

22

Using a 13mm wrench, remove the orifice for the infrared burner.

a. 

Apply pipe compound to the fitting threads where you will place the 

b. 

new orifice.

Screw on the correct orifice for your grill until it is finger tight.

c. 

Tighten the orifice with the 13mm wrench.

d. 

If you have dual infrared burners, repeat the previous steps for the 

e. 

second burner.

Replace the back cover.

f. 

Remove  the  grate,  burner  cap  and  burner  diffuser  from  the  side 

a. 

burner.

Using a 7mm wrench, remove the orifice for the burner.

b. 

Apply a small amount of pipe compound to the orifice threads.

c. 

Screw in the orifice until it is finger tight.

d. 

Tighten the orifice with the 7mm wrench.

e. 

If  you  have  dual  side  burners,  repeat  the  previous  steps  for  the 

f. 

second burner.

Remove the grates, flame tamers, and drip tray from the grill.

a. 

Remove the cotter pins from the end of the burners. The cotter pins 

b. 

are accessible from underneath the grill in the back in the accessory 

cabinet.

Carefully remove the burner.

c. 

Using  a  6mm  socket  or  nut  driver,  remove  the  orifice  for  the 

d. 

burner.

Apply a small amount of pipe compound to the orifice threads.

e. 

Screw in the orifice until it is finger tight.

f. 

Tighten the orifice with the 6mm wrench.

g. 

Repeat the above steps for the remaining burners.

h. 

Replace the burners, cotter pins, flame tamers, drip tray, and grates.

i. 

4 . 
After conversion has been completed, apply the enclosed sticker to the rating plate. The sticker reads “This 

unit has been converted from LP to NG.”

You will need:

6mm socket or nut 

• 

driver

Two to five 1.9mm 

• 

orifices (depending on 

your grill

Pipe compound

• 

You will need:

13mm open end 

• 

wrench

One #50 orifice (for 

• 

single infrared burner)

Two #54 orifices (for 

• 

dual infrared burners)

Pipe compound

• 

You will need:

7mm wrench, socket, 

• 

or nut driver

One or two 1.75mm 

• 

orifices (depending on 

your side burner)

Pipe compound

•