3com FE100 Manual De Usuario
1-12
Dell PowerEdge Cluster FE100 Installation and Troubleshooting Guide
&KHFNLQJWKH6\VWHP
When installation is complete, check the functionality of your cluster system by per-
forming a number of tests. See “Verifying the Cluster Functionality” in Chapter 3 for
specific tests and procedures to check the operation of the cluster.
forming a number of tests. See “Verifying the Cluster Functionality” in Chapter 3 for
specific tests and procedures to check the operation of the cluster.
&RQILJXULQJWKH'HOO2SHQ0DQDJH'DWD6XSHUYLVRURU
'DWD$GPLQLVWUDWRU
Refer to “Running Dell OpenManage Data Supervisor in a Cluster” and “Running
Dell OpenManage Data Administrator in a Cluster” in Chapter 3 for information about
connecting either of these utilities to the Data Agent using the cluster name.
Dell OpenManage Data Administrator in a Cluster” in Chapter 3 for information about
connecting either of these utilities to the Data Agent using the cluster name.
,QVWDOOLQJ$SSOLFDWLRQV6RIWZDUHRQWKH3RZHU(GJH
&OXVWHU)(
Additional steps are required to configure applications software to run on the cluster.
Chapter 4, “Running Applications Software on a Cluster,” provides general informa-
tion about this process and cites example procedures for setting up the Windows NT
Internet Information Service (IIS) Version 3.0 Virtual Root service, the File Share ser-
vice, and the Print Spooler service to run on a cluster.
Chapter 4, “Running Applications Software on a Cluster,” provides general informa-
tion about this process and cites example procedures for setting up the Windows NT
Internet Information Service (IIS) Version 3.0 Virtual Root service, the File Share ser-
vice, and the Print Spooler service to run on a cluster.
3RZHULQJ8SWKH3RZHU(GJH&OXVWHU)(
NOTE: DPEs contain no power switches except those on the power supply, which are
located behind the drive fan pack. Consequently, PowerVault 65xF DPEs are always
on when connected to the electrical outlet.
located behind the drive fan pack. Consequently, PowerVault 65xF DPEs are always
on when connected to the electrical outlet.
When AC power is initially applied to a DPE, the disk drives power up according to
their specifications, and they spin up in a specified sequence. The spin-up delays are
in multiples of 12 seconds. The same delay occurs when you insert a drive in a DPE
while the system is turned on.
their specifications, and they spin up in a specified sequence. The spin-up delays are
in multiples of 12 seconds. The same delay occurs when you insert a drive in a DPE
while the system is turned on.
Start the PowerEdge Cluster FE100 components in the following order:
1.
Start the PowerVault storage system first.
The first drive in the storage system begins to spin up two minutes after the stor-
age system is started. The second drive begins spinning up 12 seconds later,
followed by the third drive 12 seconds after that, and so on.
age system is started. The second drive begins spinning up 12 seconds later,
followed by the third drive 12 seconds after that, and so on.
2.
Start the primary PowerEdge node.
3.
Start the second node.