Vermont Casting DVT38IN Manual De Usuario

31

LG406
Upper logs
3/05

Log Rear Upper 

Middle (DVT44IN 

Only)

Log Front 

Upper Right

LG406

12. Position the Log Front Middle Right. 
DVT38IN only. Hold the log with the pointed end toward 

the back and the wide end toward the front. Set the 
rectangular indentation located on the bottom of 
this log over the third right tine on the grate. Lay the 
pointed end of the log over the flat area located on 
the pointed end of the front middle log. (Fig. 47)

DVT44IN only. Hold the log with the pointed end toward 

the back and the wide end toward the front. Set the 
V-shaped end on the front of this log (split area) on 
the third right tine on the grate. Lay the pointed end 
of the log over the flat area located on the pointed 
end of the front middle log. (Fig. 46)

13. Position the Log Front Right. Hold the log with the 

pointed end  toward the back and Y-branch toward 
the front. Set the rectangular indentation  located on 
the bottom over the rectangular protrusion located 
on the right grate log. Lay the pointed end of the log 
over the notched part of the overlay. When the log is 
in place, the pointed end is located on the left of the 
pilot assembly. (Fig. 46 )

14. Position the Log Front Upper Right. Hold the log 

with notched end toward the front and the pointed end 
toward the back. Set the notched end over the front 
right log. Lay the pointed end over the manifold tube 
located to the right of the burner housing. (Fig. 48)

Middle. Hold the log with split detail toward the 

front and the flat end toward the back. Set the 

round indentation located on the bottom over 
the round protrusion located on the rear left 
log toward the back. Set the right end of the 
log on the split end located on the right rear 
log toward the left. When this log is in place, it 
sets side to side. (Fig. 48)
NOTE: Refer to Figures 49 and 50 for com-

plete logset.

LG407
DVT38
front middle log
3/05

Log Front 

Middle (DVT38)

LG407