Desa (V)CD36TNE Manual De Usuario

www.desatech.com

116035-01E

FIREPLACE

INSTALLATION

Continued

Ember
Material

Ember
Tray

Figure 59 - Applying Ember Material

WARNING: The glass door

must be securely in place before

running this fireplace. Do not run

this fireplace if glass is missing

or broken.

4. Open the bag of ember materials.

5. Break apart about quarter sized pieces and

place about a single layer along the full length

of the ember tray to hide the bottom edge of

the base log. (see Figure 59).

6. Replace the glass door and louver panels. See

Removing/Replacing Glass Door, page 29.

OPERATING FIREPLACE

MILLIVOLT

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not

use any phone in your building.

• Immediately call your gas supplier

from a neighbor's phone. Follow the gas

supplier's instructions.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. If the knob

will not push in or turn by hand, don't try to

repair it, call a qualified service technician.

Force or attempted repair may result in a

fire or explosion.

D. Do not use this appliance if any part has

been under water. Immediately call a

qualified service technician to inspect the

appliance and to replace any part of the

control system and any gas control which

has been under water.

LIGHTING

INSTRUCTIONS

1. STOP! Read the safety information

above.

2. Open lower louver panel.

3. Turn off all electric power to the fire-

place.

4. Push in gas control knob slightly and turn

clockwise to “OFF” (see Figure 60).

5. Wait five (5) minutes to clear out any gas.

Then smell for gas, including near the floor.

If you smell gas, STOP! Follow “B” in the

safety information above. If you don’t smell

gas go to the next step.

6. The pilot is located by the main burner and

should not require accessing for lighting.

7. Turn gas control knob counterclockwise to

“PILOT”.

Figure 60 - Control Valve

PIL

OUT

Gas Control
Knob

Variable
Control Knob

Piezo
Ignitor