3com WXR100 3CRWXR10095A Manual De Usuario
444
C
HAPTER
11: M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
To support non-WPA clients that use static WEP, you must configure static
WEP keys. Use the set service-profile wep key-index command.
WEP keys. Use the set service-profile wep key-index command.
Examples — The following command configures service profile sp2 to
use 40-bit WEP encryption:
use 40-bit WEP encryption:
WX4400# set service-profile sp2 cipher-wep40 enable
success: change accepted.
See Also
set service-profile
cos
cos
Sets the Class-of-Service (CoS) level for static CoS.
Syntax —
set service-profile name cos level
name
— Service profile name.
level
— CoS value assigned by the MAP to all traffic in the service
profile.
Defaults — The default static CoS level is 0.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — This command applies only when static CoS is enabled. If static
CoS is disabled, prioritization is based on the QoS mode configured in the
radio profile, and on any ACLs that set CoS. (See the “Configuring
Quality of Service” chapter of the
CoS is disabled, prioritization is based on the QoS mode configured in the
radio profile, and on any ACLs that set CoS. (See the “Configuring
Quality of Service” chapter of the
.) To enable static CoS, use the set service-profile
static-cos command.
Examples — The following command changes the static CoS level to 7
(voice priority):
(voice priority):