3com WXR100 3CRWXR10095A Manual De Usuario

The valid rates depend on the radio type:

„

11a—6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0

„

11b—1.0, 2.0, 5.5, 11.0

„

11g—1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 12.0, 18.0, 24.0, 36.0, 48.0, 
54.0

Use a comma to separate multiple rates; for example: 6.0,9.0,12.0

„

disabled rate-list

 — Data transmission rates that MAP radios do 

not use to transmit data. This setting applies only to data sent by the 
MAP radios. The radios still accepts frames from clients at disabled 
data rates. 

The valid rates depend on the radio type and are the same as the valid 
rates for mandatory.

„

beacon-rate rate

 — Data rate of beacon frames sent by MAP 

radios. This rate is also used for probe-response frames. 

The valid rates depend on the radio type and are the same as the valid 
rates for mandatory. However, you cannot set the beacon rate to a 
disabled rate.

„

multicast-rate {rate | auto}

 — Data rate of multicast frames 

sent by MAP radios. 

„

—Sets the multicast rate to a specific rate. The valid rates 

depend on the radio type and are the same as the valid rates for 
mandatory. However, you cannot set the multicast rate to a 
disabled rate.

„

—Sets the multicast rate to the highest rate that can reach all 

clients connected to the MAP radio.

Defaults — This command has the following defaults:

„

mandatory:

„

11a—6.0,12.0,24.0

„

11b—1.0,2.0

„

11g—1.0,2.0,5.5,11.0

„

disabled—None. All rates applicable to the radio type are supported 
by default.