3com WXR100 3CRWXR10095A Manual De Usuario
54
C
HAPTER
3: S
YSTEM
S
ERVICE
C
OMMANDS
Examples — The following commands stage a WX switch to use the
auto-config option. The network where the switch is installed has a DHCP
server, so the switch is configured to use the MSS DHCP client to obtain
an IP address, default gateway address, DNS domain name, and DNS
server IP addresses:
auto-config option. The network where the switch is installed has a DHCP
server, so the switch is configured to use the MSS DHCP client to obtain
an IP address, default gateway address, DNS domain name, and DNS
server IP addresses:
1 Configure a VLAN:
WX-1200# set vlan 1 port 7
success: change accepted.
2 Enable the DHCP client on VLAN 1:
WX-1200# set interface 1 ip dhcp-client enable
success: change accepted.
3 Enable the auto-config option:
WX-1200# set auto-config enable
success: change accepted.
4 Save the configuration changes:
WX-1200# save config
success: configuration saved.
See Also
set banner
acknowledge
acknowledge
Configures a prompt that is displayed following the MOTD banner. The
user must acknowledge the prompt in order to gain access to the system.
user must acknowledge the prompt in order to gain access to the system.
Syntax —
set banner acknowledge mode {enable | disable}
Syntax —
set banner acknowledge message “message”
enable
— Enables the prompt to acknowledge the MOTD banner.
disable
— Disables the prompt to acknowledge the MOTD banner.
“— Delimiting character that begins and ends the prompt
message;
for example, double quotes (
“
).