3com WX2200 3CRWX220095A Manual De Usuario

C

HAPTER

 11: M

ANAGED

 A

CCESS

 P

OINT

 C

OMMANDS

To change a parameter in a radio profile, you must first disable all the 
radios in the profile. After you complete the change, you can reenable 
the radios.

To enable or disable specific radios without disabling all of them, use the 
set ap radio command.

Examples — The following command configures a new radio profile 
named rp1:

WX4400# set radio-profile rp1

success: change accepted.

The following command enables the radios that use radio profile rp1:

WX4400# set radio-profile rp1 mode enable

The following commands disable the radios that use radio profile rp1, 
change the beacon interval, then reenable the radios:

WX4400# set radio-profile rp1 mode disable

WX4400# set radio-profile rp1 beacon-interval 200

WX4400# set radio-profile rp1 mode enable

The following command enables the WPA IE on MAP radios in radio 
profile rp2:

WX4400# set radio-profile rp2 wpa-ie enable

success: change accepted.

„

„

„

„