3com WX4400 3CRWX440095A Manual De Usuario
604
C
HAPTER
17: 802.1X M
ANAGEMENT
C
OMMANDS
Usage — Normally, the Bonded Auth period needs to be set only if the
network has Bonded Auth clients that use dynamic WEP, or use WEP-40
or WEP-104 encryption with WPA or RSN. These clients can be affected
by the 802.1X reauthentication parameter or the RADIUS
Session-Timeout parameter.
network has Bonded Auth clients that use dynamic WEP, or use WEP-40
or WEP-104 encryption with WPA or RSN. These clients can be affected
by the 802.1X reauthentication parameter or the RADIUS
Session-Timeout parameter.
3Com recommends that you try 60 seconds, and change the period to a
longer value only if clients are unable to authenticate within 60 seconds.
longer value only if clients are unable to authenticate within 60 seconds.
The bonded authentication period applies only to 802.1X authentication
rules that contain the bonded option.
rules that contain the bonded option.
Examples — To set the bonded authentication period to 60 seconds,
type the following command:
type the following command:
WX4400# set dot1x bonded-period 60
success: change accepted.
See Also
set dot1x key-tx
Enables or disables the transmission of encryption key information to the
supplicant (client) in EAP over LAN (EAPoL) key messages, after
authentication is successful.
supplicant (client) in EAP over LAN (EAPoL) key messages, after
authentication is successful.
Syntax —
set dot1x key-tx {enable | disable}
enable
— Enables transmission of encryption key information to
clients.
disable
— Disables transmission of encryption key information to
clients.
Defaults — Key transmission is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.