Panasonic AG-HMR10P Manual De Usuario

34

Never remove the SD Memory Card or disconnect 
the battery or DC cable while the SD Memory 
Card access lamp is flashing, as doing so 
may damage the SD Memory Card. If you do 
accidentally remove the SD Memory Card while 
the SD Memory Card access lamp is flashing, 
or disconnect the battery or DC cable during 
recording or the recording finalization process, a 
repair verification screen is displayed the next time 
the power is switched on, allowing errors to be 
repaired.

Select [YES] to begin repairing. When repairing is 
complete, “REPAIR FINISHED” will be displayed, 
and the display will switch to the recording paused 
screen.
Select [NO] to switch directly to the recording 
paused screen without repairing.

Memory cards cannot be repaired with the 

• 

portable recorder if [NO] is selected, but can still 
be repaired by using the AVCCAM Restorer∗ 
content repair software.
An SD Memory Card on which an error occurred 

• 

can be repaired by using either the recorder unit 
that was used for the recording, or the AVCCAM 
Restorer content repair software.
A repair confirmation message may be displayed 

• 

after inserting an SD Memory Card which has no 
error, but repair will not be performed even when 
[YES] or [NO] is selected.
Repair may take up to 20 minutes or so 

• 

depending on the places where the errors 
occurred on the card.
Use a sufficiently charged battery or the AC 
adapter.
If the repair operation has failed, “SYSTEM 

• 

ERROR TURN POWER OFF” will be displayed. 
In this case, please use the AVCCAM Restorer 
content repair software.
Depending on the status of the data, it may not 
be possible to restore all data completely. In this 
case, it will no longer be possible to play back the 
clips that were recorded before the power was 
turned off.

Clips with a total recording time of less than 10 

• 

seconds may be impossible to repair.
Indexes attached during recording and metadata 

• 

cannot be repaired.

∗  AVCCAM Restorer is provided on the CD-ROM 

that is supplied with the portable recorder. Use 
it with your computer. For details on using the 
software, see the operating instructions (PDF file) 
that are included on the supplied CD-ROM. The 
AVCCAM Restorer can also be downloaded from 
the following website.
https://eww.pavc.panasonic.co.jp/pro-av/

Using the setup menus (Page 29)

When the following screen appears, select [YES] 

• 

and then press the [ENTER] button. Select [NO] 
if you do not want to format the card.
Press the [MENU] button to close the menu.

• 

The SD Memory Card will be formatted.

• 

When an SD Memory Card is formatted, all 

• 

of its recorded data will be erased, and it will 
not be subsequently possible to restore this 
data.

   Save any valuable data onto your computer 

or other storage media prior to formatting.