Radio Shack 60-479 Prospecto

Descargar
Página de 2
When the plane is coming 
towards you it appears to 
turn in the "wrong" direction.
But if you imagine yourself
in the pilots seat, the model
is in fact turning correctly. 
Try turning your back to the
aircraft and looking over 
your shoulder.
Trouble shooting
SYMPTOM CAUSE
CORRECTION
Propeller will not rotate    
ON/OFF switch is “OFF” 
Set switch to “ON” Position.
Low battery. 
Recharge battery.
Circles and descends after take off  Trim knob requires adjustment. 
Adjust the trim knob.
Can’t create lift
MicroFighters not facing the wind           Point MicroFighters into the wind 
Unable to stay in the air 
Not enough power 
Recharge MicroFighters
Poor response to transmitter 
Frequency interference may occur          Change location 
near high voltage lines, transformers
and some large buildings
Difficult to control    
Strong wind 
Only fly during extremely calm 
conditions or indoors
Loss of control 
Another controller on the same  
Change location
MicroFighter
frequency is being operated in 
the same vicinity 
Controller out of range from             
Ensure the antenna is fully  
extended and reduce distance 
Landing gear bent
Landing gear may bend on impact   
Remove landing gear from 
(
This will not affect flight performance) 
            
plane and bend back into 
position
Landing gear will not
Damage occurred during impact 
Use small amount of clear    
stay inside plane insert 
household tape to hold landing
 gear in place. 
NOTE: In the event that your MicroFighters sustains damage during impact, the problem
may be easily corrected by simply applying clear household tape to the damaged area.
Pre-Flight
• Do not touch the running propeller!
• Adult supervision is required!
• Always fly your aircraft in a large grassy area free of trees and other obstructions. 
  This will help protect your Micro Fighters during impact.
• The MicroFighters is designed for very stable outdoor flying with wind conditions not to 
   exceed 7 KPH / 4mph. If you can feel the wind, DO NOT FLY!
•  Make first flights with the landing gear on to help stabilize the flight and simplify the 
   control of this sensitive and maneuverable aircraft.  After you have gained experience you 
   can try flying with the Landing gear removed! 
• Your MicroFighters can be flown with or without landing gear. In addition to enabling realistic 
   takeoffs and landings from smooth surfaces, the landing gear has the additional function of 
   slightly degrading the performance of this sensitive aircraft and also making it more stable 
   and easier to control smoothly, especially for beginners. It is strongly recommended that 
   you make all first flights WITH the landing gear on AND to use a normal hand-launch over 
   grass. 
   Notes: ONLY after you have gained experience should you consider a ground takeoff.
• After you have advanced to the Pro Mode you can remove the stabilizing landing gear to do 
  wild maneuvers just like a full-size jet fighter!
Flying your MicroFighters
  1. Switch the MicroFighters to the “ON” position. (1) 
  2. Turn transmitter switch to “ON” position. (2) 
      The red LED will light steadily. (3)
  3. Fully extend the antenna. (4)
  4. Move throttle control (left control stick) fully forward and back 
      to activate the transmitter. (5)
  5. Make sure trim knob is centered with arrow pointing up. (6)
  6. Push throttle control forward to half (middle) before launch 
      for FIRST flights. 
  7. Hold the nose of the MicroFighters with two fingers to launch. (7) 
  8. Launch the MicroFighters as straight and level as possible; 
      always launch gently INTO the wind. (8)
  9. Add throttle gently while adjusting the steering trim
      knob on the transmitter.  
10. Adjust trim Left when the MicroFighters turns Right.
11. Adjust trim Right when the MicroFighters turns Left.  
12. Repeat steps (10) and (11) several times to make sure 
      your MicroFighters travels in a straight line.
Control Reversal
Advanced Flight Techniques 
MicroFighters is designed to make sharper and tighter turns as you reduce the throttle
power! Maximum turning will be during gliding. Control is thus less sensitive during 
full throttle.
Sharp turns can be performed by quickly reducing throttle power to pitch the nose up
and to increase control sensitivity.  Then while holding the right stick for a turn, you can
precisely control the amount or radius of the turn with the “LEFT” (throttle) stick: pushing
forward on the LEFT stick widens the turn; pulling back the “LEFT” stick tightens the 
turn. The left stick functions as an ELEVATOR control in this case!
Once the inside wing begins to bank a little move right stick back to center. 
The MicroFighters will maintain the turn by itself; push right stick in opposite direction 
to straighten out.
NOTE: Your MicroFighters is designed to self-stabilize automatically when power
is reduced. In an "emergency" situation in which the plane is out of control, 
quickly pulling the left throttle stick ALL the way back to stop the motors will 
let the plane save itself and not crash!
To land your MicroFighters direct it INTO any slight wind and decrease throttle for slow
and steady descent. For perfect landings on smooth surfaces with the landing gear 
however, land WITH the wind in the same direction it is blowing for a gentle touchdown. 
To let your MicroFighters take off from any smooth surface allow about 17 m / 50 ft takeoff run 
and even more clear space for climb out. Point it INTO any slight wind and give full power while making careful steering
corrections. Practice with your MicroFighters until you are confident and skilled enough to cancel the restricting 
feature of Easy Mode and use the Pro Mode. To switch over to Pro Mode:  BEFORE you turn on the controller, hold the
RIGHT stick hard over to the right.  Then turn on the controller while still holding the RIGHT stick to the right. You can
release the right stick and the red LED will blink three times indicating you have activated Pro Mode and deactivated
the Easy Mode! Move the LEFT stick forward and back once to enable the controller as before.
2
4
6
5
3
7
8
1