Combi 8100 Manual De Usuario

After selecting a seating location, 
if adjustable, adjust vehicle seat 
back into most upright position.

Rotate car seat on lower base to 
rear-facing position, see “Changing 
Forward-Facing/Rear-Facing Use 
Position” section.

Remove the lower anchor connectors 
from their storage locations on back 
of car seat pad (fig. a).

- Depress spring on hook-on 

connector (fig. b) and remove 
from LATCH connector storage
ring.  

Lengthen lower anchor belt by
pressing down on belt adjuster
slide button on top of belt 
adjuster and pulling belt to 
extend the length of lower 
anchor belt (fig. c).

Check that the lower anchor belt is through 
the belt path openings marked “Belt Here 
Rear-facing” (fig. d). If lower anchor belt is 
not through the rear-facing belt path openings, 
see “LATCH - Changing Belt Path Location” 
section.

Place car seat rear-facing in the vehicle 
seat location selected with rear-facing
belt path toward vehicle seat back and 
centered between the vehicle lower 
anchors (fig. d).

Recline car seat keeping the line inside 
level indicator in the green striped zone 
(fig. e). To change recline position, see
“Recline Position Adjustment” section.

NOTE: Level indicator is located on the

opposite side of car seat and not
on the side shown.