GTO R4854 01 Manual De Usuario

  GTO 4000XLS Instruction Manual © 01.10.12

Pull-To-Open Gates (Gate Opens into the Property)
The diagram shown below is an example of a Pull-To-Open installation on a chain link fence and single 

gate.  Mounting the operator on a masonry column requires special procedures; see Column Installation 

Information on page 23. Furthermore, if you have a Push-To-Open gate, see Push-To-Open Installation on 

page 21 before proceeding. 

The post bracket is designed to work on a flat post. Posts

must be at least 6” square in order to bolt the post bracket. 

When using bolts to mount the post bracket, the bolts must 

completely penetrate the post. 

•  The best method of attaching the post bracket to a metal

post is welding. 

•  If your post exceeds 8”, it will be necessary to use hex

head bolts longer than those supplied. 

•  Round wood posts (no smaller than 8” diameter) may be

notched to create a flat surface for attaching the post

bracket. 

•  Wood posts will require a metal plate (not provided)

between the nuts and post to prevent the operator from 

pulling the bolts and washers through the wood. 

•  A post smaller than 6” in diameter should be made of

metal instead of wood so that it will remain stable while 

the operator is moving the gate. 

•  Masonry columns will require masonry anchors/

hardware (not provided).

 

Horizontal Cross Member

Gate Swings Evenly and Freely

Hung Firmly and Plumb

Receiver

Post Bracket Assembly

Control Box with Battery 

Gate Bracket

Single Gate Opener

Fence Post Set in Concrete

Run 1000' (max.) of low

voltage wire to control

box from transformer

(wire not included).           

Power Cable

Closed Position Stop Plate

120 Volt indoor

Transformer

(surge protector 

not supplied)

PVC conduit (not included)

to protect wire from lawn

mowers and weed eaters.

Warning Sign