Cisco Systems 2960 Manual De Usuario
C H A P T E R
22-1
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
22
Configuring IGMP Snooping and MVR
Note
To use MVR, the switch must be running the LAN Base image.
This chapter describes how to configure Internet Group Management Protocol (IGMP) snooping on the
Catalyst 2960 and 2960-S switches, including an application of local IGMP snooping, Multicast VLAN
Registration (MVR). It also includes procedures for controlling multicast group membership by using
IGMP filtering and procedures for configuring the IGMP throttling action. Unless otherwise noted, the
term switch refers to a standalone switch and a switch stack.
Catalyst 2960 and 2960-S switches, including an application of local IGMP snooping, Multicast VLAN
Registration (MVR). It also includes procedures for controlling multicast group membership by using
IGMP filtering and procedures for configuring the IGMP throttling action. Unless otherwise noted, the
term switch refers to a standalone switch and a switch stack.
Note
Stacking is supported only on Catalyst 2960-S switches running the LAN base image.
For complete syntax and usage information for the commands used in this chapter, see the switch
command reference for this release and the “IP Multicast Routing Commands” section in the Cisco IOS
IP Command Reference, Volume 3 of 3:Multicast, Release 12.2 from the Cisco.com page under
Documentation > Cisco IOS Software > 12.2 Mainline > Command References.
command reference for this release and the “IP Multicast Routing Commands” section in the Cisco IOS
IP Command Reference, Volume 3 of 3:Multicast, Release 12.2 from the Cisco.com page under
Documentation > Cisco IOS Software > 12.2 Mainline > Command References.
This chapter consists of these sections:
•
•
•
•
•
•
•
•
Note
You can either manage IP multicast group addresses through features such as IGMP snooping and MVR,
or you can use static IP addresses.
or you can use static IP addresses.