Cisco Systems 2960 Manual De Usuario

Beginning in privileged EXEC mode, use this command to ping another device on the network from the 
switch:

Though other protocol keywords are available with the ping command, they are not supported in this 
release.

This example shows how to ping an IP host:

Switch# ping 172.20.52.3

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echoes to 172.20.52.3, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms

Switch#

 describes the possible ping character output.

To end a ping session, enter the escape sequence (Ctrl-^ X by default). Simultaneously press and release 
the Ctrl, Shift, and 6 keys and then press the X key. 

These sections contain this information:

ping ip host | address

Ping a remote host through IP or by supplying the hostname or 
network address.

!

Each exclamation point means receipt of a reply.

.

Each period means the network server timed out while waiting for a reply.

U

A destination unreachable error PDU was received.

C

A congestion experienced packet was received.

I

User interrupted test.

?

Unknown packet type.

&

Packet lifetime exceeded.