Graco 2L01VIB Manual De Usuario

Parent Unit
• Remove the battery door cover on the  

Parent Unit with a key or flat blade screw 
driver. 

• Place 3-AAA (1.5V-LR03) batteries into 

the battery compartment. Note the  
proper orientation of the batteries.

• Do not mix old and new batteries. 
• Do not mix alkaline, standard 

 (carbon zinc), or rechargeable 
 (ni-cadmium, etc) batteries.

• Place the battery door back on the unit.
• Please remove a dead battery promptly. 

A dead battery left in the unit may leak, 
damaging your unit.

• Do not attempt to recharge a  

non-rechargeable battery.

• A rechargeable battery CANNOT be recharged by plugging the AC adapter into the 

Parent Unit.

• Remove the batteries from the unit if it is no longer being used or will be stored for an 

extended period of time.

• The Parent Unit uses 3-AAA (1.5V-LR03) batteries or standard 120 volt AC household 

current. The Nursery Unit uses standard 120 volt AC household current. 

• To use AC adapters, plug the connector on the cord into the AC adapter jack on the side 

of the Parent Unit and the back of the Nursery Unit.  Then plug adapter into a standard 
wall outlet. 

 • Use ONLY the Graco adapters included with the unit. Do not use these adapters with 

other equipment under any circumstances. 

• If units do not work, check that AC adapters are plugged into working outlets. 

Batteries should be disposed of 

properly by recycling.

• In case you are experiencing some interference, the 

channel on the Nursery Unit can be changed by sliding 
the “ch” button on the side of the unit to either  
channel A or B ("X" or "Y").  

• The channel on the Parent Unit can be changed by 

sliding the “ch” button on the side of the unit to either 
channel A or B ("X" or "Y").    
 
NOTE: Both units must be on the same channel.

A

B

A

B