Britax 55 Manual De Usuario

Descargar
Página de 70
30
Before You Begin:
•  Check that your vehicle has lower anchors.
*  Refer to your vehicle owner’s manual or contact the vehicle 
manufacturer for the maximum weight rating for their lower 
anchors. Use vehicle belt (not lower connectors) for installations 
with children who weigh more than the vehicle lower anchor limit. 
Unless specified otherwise by the vehicle manufacturer, assume  
a 40 pound (18.1 kg) child is the vehicle lower anchor limit.
•  Remove the lower connectors from the storage slots in the base. 
Press the adjuster release button and pull the strap to full length. 
Repeat for the second strap.
•  This child seat must be reclined to position 3 and placed  
rear-facing on the vehicle seat.  
*  When properly installed in the rear-facing 
position, the back angle of the child seat 
should be at least 30˚ for children and 
up to 45˚ from vertical for infants unable 
to maintain head and neck control (not 
to exceed 45˚) when the car is parked 
on a level surface. Use the blue line as a 
guide to achieve the proper recline angle 
for rear-facing installations. The blue line 
will be parallel to the ground when the child seat angle is at the 
center of the angle range (30 – 45˚). If necessary, the proper 
recline angle can be achieved by placing a rolled towel or pool 
noodle in the vehicle seat bight.
•  Britax recommends that the Versa-Tether is used at all times. Using 
the tether will improve the stability of the child seat and reduce the 
risk of injury. Check your vehicle owner’s manual for tether anchor 
locations. See page 27 for possible rear-facing tether configurations.
LATCH Installation
Rear-Facing Installation