Bradford-White Corp 238-42498-00J REV 10/06 Manual De Usuario
Internet Version for Reference Only
Installation (Vent-Air Intake System Installation) continued-
12. Mark the mounting screw hole locations for the backing plate. Rotate
the backing plate in order to gain access to the markings. With a 3/16
(4.75 mm) inch diameter drill bit (not supplied), drill holes for the
supplied wall anchors. Install the wall anchors and secure the backing
plate to the wall with four (4) #10 x 1 inch screws (supplied) (See Figure
16). Note: Certain construction of walls may require the use of a
different type of anchoring means than supplied.
(4.75 mm) inch diameter drill bit (not supplied), drill holes for the
supplied wall anchors. Install the wall anchors and secure the backing
plate to the wall with four (4) #10 x 1 inch screws (supplied) (See Figure
16). Note: Certain construction of walls may require the use of a
different type of anchoring means than supplied.
Figure 16.
IMPORTANT
When the installation is complete, visually inspect the air intake
system to insure that all joints are completely sealed.
system to insure that all joints are completely sealed.
24