Panasonic NE1757R Manual De Usuario

Disconnect the power cord from the wall socket 

1. 

before attempting installation.
For stacking installation, you must use the 

2. 

PANASONIC Joint Plate which is enclosed with this 
unit.
The combination of the units for stacking is limited 

3. 

to only the following PANASONIC models: 

NE-1247, NE-1257, NE-1258, NE-1757, NE-2157, 
NE-DF20G
The 

4. 

maximum stacking height is the total heights of 

two units.

Be sure the oven cavity is empty. Be sure surfaces 
where ovens meet is clean and sanitized.

Stack the units and remove five screws (a) as shown in Fig.1.

1. 

Loosen the screw (b).

2. 

Projection on Joint Plate must face away from the oven. Place Joint Plate on the screw (b).

3. 

Attach and tighten five screws (a) and the screw (b). See Fig.2.

4. 

Ensure the top oven is at a safe and workable height.

5. 

(b)

Joint Plate

Projection

(a)

Fig. 1

Joint Plate

Projection

Fig. 2

Microwave oven should be located on a level 

1. 

counter top surface. Complete the electrical 
connections.
Thoroughly clean the microwave oven bottom 

2. 

perimeter and the counter top area around the 
microwave oven perimeter.
Lay generous bead of silicone seal around the 

3. 

entire perimeter of the base of each microwave 
oven unit.
Smooth the silicone seal into the crevice with finger 

4. 

or tool to provide a cove seal.

Note:    Remove the Air Filter from the front of the oven 

before applying silicone. 
DO NOT FORGET to re-install the Air Filter 
after applying silicone.

Silicone Sealant

Counter Top