Crown Boiler 24-05 Manual De Usuario

88

    For use with ESBE ½” to 6” 3-Way and 4-Way rotary valves for mixing and diverting applications. Use with 24Vac 3-point “floating” signal controller.

1. Place drive sleeve  onto shaft and secure with bolt . Check that the valve is in mid-position (sleeve pointer set to position 5 on scale plate).

2. Mount threaded stud  in one of the threaded holes. For 1½” and 2" valves replace one of the cover bolts with the threaded rod. Tighten 

    mounting piece  onto threaded rod.

3. Mount handle  over drive sleeve set pointer to 5 on the scale plate. Handle must be mounted opposite to the pointer of the drive sleeve.

4. Mount motor onto sleeve so that the mounting piece m fits into the locking piece o. Push locking piece to lock in place. Labels are supplied

    to indicate the direction of rotation. Determine the direction of rotation and mount the correct label under the plastic front cover of motor.

Always disconnect power before operating by hand. Note 

position of drive sleeve pointer to be returned to. Depress 

the  gray  button,  “A”,  on  the  side  to  release 

the  handle.  The  valve  can  now  be  operated 

manually. 

Adjusting Cams 
The position of the cams is changed by fitting a screw-

driver in the slot and moving the cam to the desired 

position.The topmost cam operates the auxiliary 

switch (upper switch – NOT USED). The middle and 

lower cams determine the degree of rotation (30° to 

180°). To access, remove the actuator cover to gain 

access to the middle and lower cams.The valve rota-

tion must be set before operation can begin.  Adjust 

the cam so that each end switch is made when the 

valve is fully open (pointer towards “0”) and when the 

valve is fully closed (pointer towards “10”).  Depress 

the “Test” switch on the RTC control to test for proper valve operation.