Cleveland Range 22CGT3 Manual De Usuario

 

If the installer smells gas, or suspects there is a gas leak, immediately refer to 
the posted gas leak instructions. The posted instructions are provided by the 
local gas supplier and supersede any other instructions. 

 

 
 
 
 
 
 
 
 
 
 
 
If a gas leak is suspected, observe the following precautions in addition to the posted instructions: 

•  Do NOT light or start any appliance. 

•  Do NOT touch any electrical switch. 

•  Do NOT use any phone in the building. 

•  Immediately call the gas supplier from a phone away from the building. 

•  Follow the gas supplier’s instructions. 

•  If the gas supplier cannot be reached, call the fire department. 

 

•  Gas supply type MUST match the type of gas shown on the rating plate. 

•  Gas supply pressure must NOT exceed 14” water column (1/2 psi), and fall within the acceptable 

pressure range shown below when using 3/4” NPT line and a 1/2” NPT connection 

•  Natural gas pressure at 1000 BTU/CF must be between 7” – 14” water column. 

•  If the gas supply pressure exceeds 14” water column, a pressure regulating valve (pressure 

regulator) must be installed in gas supply plumbing to reduce pressure to the SteamChef.      
See Figure 3-1. 

 

The Installer / owner is responsible for furnishing and installing gas supply lines, valves, 
regulators, and accessories. 

When installing gas supply lines and accessories, observe the following: 

a.  Refer to Figure 3-1 for the recommended layout of the gas supply lines. 

b.  Use a non-hardening pipe thread sealant resistant to LP gas. 

c.  The ½” NPT gas inlet is on the back of the SteamChef. See Figure 1-2 

d.  Install main manual shut off valve between gas supply and the SteamChef. See Figure 3-3. This 

main manual shut off valve is called the “Main Manual Gas Valve.” 

e.  Install a sediment trap (drip leg) in gas supply line. See Figure 3-3. 

 

 

 
 
 
 
 
 
 
 
 

 

 

 

 

Gas Supply Line Layout