U-Line ADA24RG Manual De Usuario
U-Line Door Panel Installationl
10
9 Door Panel Installation
Custom 1/4'' Thick Door Panel Insert
Door Panel Preparation
A custom door panel may be inserted into the doorframe. Custom
door panels can be flat or raised, as long as the maximum panel
thickness where inserted into the door reveal (channel) is no more
than 1/4" thick. For raised panels, the depth of the reveal is 1/4" on
all four sides.
door panels can be flat or raised, as long as the maximum panel
thickness where inserted into the door reveal (channel) is no more
than 1/4" thick. For raised panels, the depth of the reveal is 1/4" on
all four sides.
IMPORTANT
IMPORTANT
Raised panels will reduce the door’s 90° swing/zero
clearance if the unit is installed next to a wall or similar
type of structure.
clearance if the unit is installed next to a wall or similar
type of structure.
Panel Dimensions.
The door panel must not weigh more than 20 lbs.
Door Panel Installation
Install the insert as follows:
CAUTION
Use care when handling the insert. Insert edges may be
sharp.
sharp.
1. Remove top hinge screw pin
with Phillips head screwdriver.
Remove door by tilting
forward and lifting off bottom
hinge pin.
Remove door by tilting
forward and lifting off bottom
hinge pin.
Model
Width
Height
ADA24RB
22 15/16”
26 15/16”
1175R(B/W)
22 15/16”
26 15/16”
1115R(B/W)
13 15/16”
26 15/16”
29R(B/W)
19 13/16”
21 13/32”
2. Pull door gasket out of groove (top
edge of door only). Start in the
middle and pull outward, moving
toward the edge. This may take some
force.
middle and pull outward, moving
toward the edge. This may take some
force.
3. Remove two outside screws holding
door handle. Slightly separate door
handle from door .
handle from door .
4. Pull handle up and off.
5. Slide custom door panel insert into 1/4-inch channel in door
front.
IMPORTANT
IMPORTANT
Use care not to damage magnet , located on door bottom
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
6. Holding door gasket out of the way, replace handle on door,
making sure it is seated properly on insert and that screw holes
line up.
line up.
7. Install two small screws removed in Step 3.
8. Starting at the corners and working inward, push door gasket
into place on door.
9. Place door on bottom hinge pin and install upper hinge screw.