Indesit DIMNS53KC.AIXGB Guía Del Usuario

Disconnect your appliance from the electricity supply before carrying out 

any work on it.

•  The stainless steel or enamel-coated external parts and the rubber seals 

may be cleaned using a sponge that has been soaked in lukewarm water 

and neutral soap. Use specialised products for the removal of stubborn 

stains. After cleaning, rinse and dry thoroughly. Do not use abrasive 

powders or corrosive substances.

•  The inside of the oven should ideally be cleaned after each use, while it is 

still lukewarm. Use hot water and detergent, then rinse well and dry with 

a soft cloth. Do not use abrasive products.

•  All accessories - with the exception of the sliding racks - can be washed 

like everyday crockery, and are even dishwasher safe.

•  We recommend that detergents are not sprayed directly onto the control 

panel, but that a sponge is used instead.

! Never use steam cleaners or pressure cleaners on the appliance.

Clean the glass part of the oven door using a sponge and a non-abrasive 

cleaning product, then dry thoroughly with a soft cloth. Do not use rough 

abrasive material or sharp metal scrapers as these could scratch the surface 

and cause the glass to crack. For more thorough cleaning purposes, the oven 

door may be removed:

1. Open the oven door fully (see diagram);

2. Lift up and turn the small levers located on 

the two hinges (see diagram);

3. Grip the door on the two external sides 

and close it approximately half way. Pull the 

door towards you, lifting it out of its slot (see 

diagram). 

To replace the door, reverse this sequence.

WHEN USING THE MAIN OVEN 
YOU MUST ENSURE THAT THE 

BASE OF THE CAVITY IS NOT 
COVERED WITH ALUMINUM 
FOIL, UTENSIL OR ANY OTHER 
FORM OF COVERING. FAILURE 
TO DO THIS MAY RESULT IN 
THE CAVITY BEING DAMAGED. 

Check the door seals around the oven regularly. If the seals are damaged, 

please contact your nearest Service Centre (see Assistance). We recommend 

that the oven is not used until the seals have been replaced.

Pour changer l’ampoule d’éclairage 

du four:

1. Dévissez le couvercle en verre du 

boîtier de la lampe.

2. Dévissez l’ampoule et remplacez-

la par une autre de même type : 

puissance 25 W, culot E 14.

3. Remontez le couvercle à sa place 

(voir figure).

! Ne pas utiliser la lampe du four comme éclairage de la pièce.