Indesit IT50G1XX Guía Del Usuario

•  turn the knob to Max for about 10 minutes and then 

turn the knob to the Min setting;

•  remove the knob;
•  regulate the screw positioned outside the thermostat 

pin until the flame is small but steady.
! in the case of liquid gas, the regulation screw must 
be screwed in to the bottom.

 

• 

check that the burner does not turn off when you 
turn the knob from Max to Min and and when you 
open and close the oven door quickly.

Replacing the nozzle of the grill burner:
•  remove the screw and then slide out the grill burner 

“V” (see Figure);

•  unscrew the grill burner nozzle using the special 

socket spanner for the nozzles (see Figure) or better 
still a 7mm socket spanner; replace the nozzle with 

a nozzle 
for the 
new type 
of gas 
(see table 
1).

Important
On completion of the operation, replace the old rating 
sticker with one indicating the new type of gas used. 
This sticker is available from our Service Centres.

Note
Should the pressure of the gas used be different (or 
vary) from the recommended pressure, it is necessary 
to fit a suitable pressure regulator onto the inlet pipe in 
compliance with current National Regulations relative 
to “regulators for channelled gas”.