Brother HE-120 Manual De Propietario
Overcasting Stitches 77
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e
Pass the upper thread under the side cutter,
and then pull it out toward the rear of the
sewing machine.
and then pull it out toward the rear of the
sewing machine.
f
Select a stitch.
• For details, refer to "Selecting stitching" (page
47).
g
Make a cut of about 2 cm (3/4 inch) long in
the fabric at the beginning of the stitching.
the fabric at the beginning of the stitching.
a
2 cm (3/4 inch)
h
Position the fabric in the side cutter.
The cut in the fabric should be positioned over
the guide plate of the side cutter.
The cut in the fabric should be positioned over
the guide plate of the side cutter.
a
Guide plate
• If the fabric is not positioned correctly, the
fabric will not be cut.
i
Lower the presser foot lever, and then start
sewing.
sewing.
X
A seam allowance is cut while the stitching
is sewn.
is sewn.
• If the stitching is sewn in a straight line
63
,
the seam allowance will be about 5 mm
(3/16 inch).
(3/16 inch).
a
5 mm (3/16 inch)
Memo
z The side cutter can cut as much as one layer
of 13-oz. denim.
z After using the side cutter, clean it by
removing any lint or dust.
z If the side cutter can no longer cut fabric,
use a rag to apply a small amount of oil to
the cutting edge of the cutter.
the cutting edge of the cutter.
1
1
1
SE-BrotherE_sgml.book Page 77 Monday, June 30, 2003 3:44 PM