Allied Telesis AT-CV5000 Manual De Usuario

Chapter 2: Installation

60

This section describes how to power on an AC powered AT-CV5000 
chassis. If your chassis is DC powered, see “Powering On a DC Powered 
Chassis” on page 64. 

The AT-CV5000 chassis is shipped without any power supplies 
installed. You must install at least one power supply in order to 
power on the chassis. For information about installing an AC power 
supply, refer to “Installing an AT-PWR14 AC Power Supply” on 
page 82.

The AT-CV5000 Media Converter chassis can contain two power 
supplies of the same type (AC or DC) or a combination of the two 
versions with the same power ratings. Make sure not to mix power 
supplies with different power ratings in the same chassis.

For information on the power supply module, refer to the 
documentation that is shipped with the module.

The AT-PWR14 AC power supply is shipped with four power cords, 
one each for North America, the UK, Europe, and Australia. Locate 
the correct power cord for your location before beginning this 
procedure.

To power on an AC powered chassis, perform the following procedure:

1. Make sure that the ON/OFF power switch is in the OFF position, as 

shown in Figure 36.

Figure 36. ON/OFF Power Switch in OFF Position

PWR A

PWR B

1131

277