Allied Telesis AT-CV5000 Manual De Usuario

Chapter 2: Installation

70

The procedure in this section explains how to start a remote management 
session using the 10/100Base-TX port on the AT-CV5M01 Management 
Card on the chassis. You can use a remote management session to 
configure the chassis operating parameters and view performance and 
error statistics using the AT-S70 management software. 

To manage a chassis remotely, you must first assign an IP address to it. 
For information about assigning an IP address to the system, refer to 
Chapter 1, “Getting Started,” in the AT-S70 Management Software User’s 
Guide.

To start a remote management session, perform the following procedure:

1. Connect a twisted pair cable to the 10/100Base-TX port on the front of 

the AT-CV5M01 Management Card, as shown in Figure 47.

Figure 47. Connecting a Twisted Pair Cable to the 10/100Base-TX Port on 

the AT-CV5M01 Management Card

The RJ-45 port runs in MDIX mode. Be sure to use the proper cable. 
The connector and port pinouts are shown in “RJ-45 Twisted Pair 
Port Pinouts” on page 103.

2. In the Telnet application, specify the IP address of the AT-CV5000 

chassis that you want to access.

The software initializes and then the login prompt is displayed.

3. Press <Return> twice.

4. When prompted, enter a username and password.

ˆ

To configure the chassis settings, enter “manager” as the 
username. The default password for manager access is “friend”. 

ˆ

To just view the settings, enter “operator” as the username. The 
default password for operator access is “operator”.

245