Allied Telesis AT-CV5000 Manual De Usuario

Chapter 3: Working with Line Cards and other Modules

76

This section contains the following procedures:

ˆ

ˆ

ˆ

This section describes how to install an AT-CV5M01 Management Card. 

The AT-CV5M01 Management Card is hot-swappable. You can 
install it without powering off the Converteon™ chassis.

To install an AT-CV5M01 Management Card, perform the following 
procedure:

1. Remove the AT-CV5M01 Management Card from its shipping 

package and store the package in a safe place. 

You must use the original package if you need to return the unit to 
Allied Telesis.

2. Select any line card slot in the AT-CV5000 chassis where you want to 

install the management card and remove the slot cover, if installed.

3. Align the back edge of the management card with the top and bottom 

alignment guides located inside the slot.

Avoid touching the line card components.

Warning: Remove all metal jewelry, such as rings and watches, 
before installing or removing a line card from a powered-on 
chassis. 

 E26

Caution: Be sure to observe all standard electrostatic discharge 
(ESD) precautions, such as wearing an antistatic wrist strap, to 
avoid damaging the device. A line card can be damaged by 
static electricity.