Ultimate Support Systems ts 90 Prospecto

STEP 5
Line up arrow TeleLock® collar with “RAISE”. Then raise center tube 
6-10”. Put speaker cabinet on top of the stand and raise the cabinet 
to desired height. Set to “LOCK” position.

STEP 6
To lower speakers, SLOWLY rotate arrow on TeleLock collar to  
“LOWER” position until speaker starts to lower. To slow descent,  
turn collar toward the “RAISE” position. When ready to remove the
speaker, rotate collar to “LOCKED” position.

1. Occasionally clean the stand with a damp 
cloth or non-abrasive cleaner.

2. When loading the stand, ONLY add the 
speaker when the stand is in a fully upright 
position (all legs on the floor).

3. Do not drag the stand while it is loaded; 
this could break the fittings and result in 
damage to the stand which will not be 
covered under warranty.

4. Check that the leg collar is securely locked 
when supporting equipment.

5. Always release the TeleLock collar with 
caution and stand clear of the load.

6. The stand is equipped with a tube lock 
which prevents accidentally pulling out the 
center tube.

STEP 1
Open leg fitting lock lever.

STEP 2 
Turn stand upside down and pivot legs so Ultimate Support label 
faces you.

STEP 3 
Turn stand upright and slide leg fitting to adjust diameter of leg 
spread. Leg braces should be parallel to floor for maximum stability. 
Close lock lever.

STEP 4
The built-in adapter fits both 1-1/2” or 1-3/8” internal diameter speaker 
sockets. Use the lower position for 1-1/2”. For 1-3/8” sockets, depress 
push buttons and raise adapter until it locks in raised 

position.

Turn a Tall TS-99B, or TS-99BL Speaker 
Stand into a Lighting Tree.

For a Single-Tier Lighting Tree add:
LTB-48B (#14107) 
48” Lighting Crossbar

For a Two-Tier Lighting Tree add:
LTV-24B (#14108)  24” Vertical Extension
LTB-48B (#14107)  48” Lighting Crossbar
LTB-24B (#14106)  24” Lighting Crossbar Pair

External bracket securely mounts any 
speaker cabinet with a flat bottom on 
an Ultimate Support speaker stand.

Internal metal bracket securely mounts 
any speaker cabinet with a flat bottom 
on an Ultimate Support speaker stand.

Heavy-duty, padded, zippered 
Tote Bags

Holds one TS-90B Speaker Stand.
10.5” x 49.5” (267 mm x 1257 mm)

Holds two TS-90B Speaker Stands.
14.5” x 49.5” (368 mm x 1257 mm)

Holds one 

TS-99B/TS-99BL

 Speaker Stand.

10.5” x 60.5” (267 mm x 1537 mm)

Holds two 

TS-99B/TS-99BL

 Speaker Stands.

14.5” x 60.5” (368 mm x 1537 mm)