Empire Comfort Systems PV-28SV55-(C,G)2H(N,P)-1 Manual De Usuario

24820-1-0409

Page 48

The  main  convection  fan  in  the  heater  should  be  checked,  ser-

viced and cleaned annually by a qualified service person to ensure 

that your appliance is operating efficiently.

Note:  If the main convection fan becomes clogged with lint and 

dust an over-temperature situation will occur through the 

heater exchange system and the over-temperature safety 

switch will stop the heater from operating.

The heat exchanger of the unit is located at the rear of the heater. 

The heat exchanger should be inspected annually by a qualified 

service person for lint and dust build up. Excessive dust and lint 

build-up in the heat exchanger can alter the unit’s performance 

and operation.
Note:  This appliance (Insert and Freestanding Models) needs 

to be installed in such a way that the heater (especially 

with models built into a fireplace) can be removed at all 

times to service the heat exchanger and flue fan, which 

are located at the rear section of the heater.
Under no circumstances should the appliance be installed 

under conditions that would not allow for easy removal 

of the appliance to carry out routine inspection and ser-

vice work on the appliance. 

DISCONNECT  MAIN  POWER  PRIOR  TO  STARTING 

ANY WORK ON THE APPLIANCE. 

1.  Remove Fireplace Insert Surround assembly from carton, handle insert surround with care to avoid paint damage.

2.  Assembly Fireplace Insert Surround as per diagram with four (4) 10 x 1/2” screws supplied.

3.  Install surround assembly around fireplace.

4.  Install either slim or short top. Note: Top will hold surround in place.

COMBUSTION AIR

INTAKE SLOT

COMBUSTION AIR

DEFLECTOR

SURROUND TOP

SURROUND SIDE

4 SCREWS

22754

Top, Surround Assembly

1

21859

Side, Surround 6”

2

Replacement 10 x 1/2” screws can be purchased from a local hardware store.