Guardian Technologies 004702-0 Manual De Usuario

 

 

3

• Before performing any maintenance on the gen-

erator, disconnect its battery cables to prevent 
accidental start up. Disconnect the cable from the 
battery post indicated by a NEGATIVE, NEG or (–) 
first. Reconnect that cable last.

• Never use the generator or any of its parts as a 

step. Stepping on the unit can stress and break 
parts, and may result in dangerous operating con-
ditions from leaking exhaust gases, fuel leakage, 
oil leakage, etc.





• The generator covered by this manual produces 

dangerous electrical voltages and can cause fatal 
electrical shock. Avoid contact with bare wires, ter-
minals, connections, etc., while the unit is running. 
Ensure all appropriate covers, guards and barriers 
are in place before operating the generator. If work 
must be done around an operating unit, stand on 
an insulated, dry surface to reduce shock hazard.

• Do not handle any kind of electrical device while 

standing in water, while barefoot, or while hands or 
feet are wet. DANGEROUS ELECTRICAL SHOCK 
MAY RESULT.

• During installation onto the vehicle, have the 

generator properly grounded (bonded) either by 
solid mounting to the vehicle frame or chassis, 
or by means of an approved bonding conductor. 
DO NOT disconnect the bonding conductor, if so 
equipped. DO NOT reconnect the bonding conduc-
tor to any generator part that might be removed or 
disassembled during routine maintenance. If the 
grounding conductor must be replaced, use only a 
flexible conductor that is of No. 8 American Wire 
Gauge (AWG) copper wire minimum.

•  In case of accident caused by electric shock, imme-

diately shut down the source of electrical power. 
If this is not possible, attempt to free the victim 
from the live conductor. AVOID DIRECT CONTACT 
WITH THE VICTIM. Use a nonconducting imple-
ment, such as a rope or board, to free the victim 
from the live conductor. If the victim is uncon-
scious, apply first aid and get immediate medical 
help.

• Never wear jewelry when working on this equip-

ment. Jewelry can conduct electricity resulting in 
electric shock, or may get caught in moving com-
ponents causing injury.





• For fire safety, the generator must be installed 

and maintained properly. Installation always must 
comply with applicable codes, standards, laws 
and regulations. Adhere strictly to local, state and 
national electrical and building codes. Comply 
with regulations the Occupational Safety and 
Health Administration (OSHA) has established. 
Also, ensure that the generator is installed in 
accordance with the manufacturer’s instructions 
and recommendations. Following proper installa-
tion, do nothing that might alter a safe installation 
and render the unit in noncompliance with the 
aforementioned codes, standards, laws and regula-
tions.

•  Keep a fire extinguisher in the vehicle at all times. 

Extinguishers rated “ABC” by the National Fire 
Protection Association are appropriate for use on 
the recreational vehicle generator electrical sys-
tem. Keep the extinguisher properly charged and 
be familiar with its use. If there are any questions 
pertaining to fire extinguishers, consult the local 
fire department.





•  Do not smoke around the generator. Wipe up any 

fuel or oil spills immediately. Ensure that no com-
bustible materials are left in the generator com-
partment, or on or near the generator, as FIRE or 
EXPLOSION may result. Keep the area surround-
ing the generator clean and free from debris.

•  Gasoline is extremely FLAMMABLE and its vapors 

are EXPLOSIVE. Do not permit smoking, open 
flame, sparks or any source of heat in the vicinity 
while handling gasoline. Comply with all laws gov-
erning the storage and handling of gasoline.

• This generator may use liquid propane (LP) gas 

as a fuel. LP gas is highly EXPLOSIVE. The gas is 
heavier than air and tends to settle in low areas 
where even the slightest spark can ignite the gas 
and cause an explosion.