Alesis 12 FireWire Manual De Usuario

Descargar
Página de 64
 
A Tour of the MultiMix FireWire
 
2
 
 
 
15 
even added to the main mix via the 2TK TO MIX switch in the 
master section of  the mixer. 
 
The 2-TRACK INPUT is blended with any signal coming back 
from a computer over the Firewire connection. 
 
MAIN MIX OUT 
 
These 1/4” jacks are where the signal on the main mix bus leaves 
the mixer. From there you can send it to a recorder or a PA system. 
The level of  this signal is controlled by the MAIN MIX fader.  
 
CTRL RM OUT 
 
You can use these 1/4" jacks to send the control room signal to 
the input of  the amplifier driving your monitors or headphones. 
This output can carry several different signals, depending on which 
source you have selected in the master section of  the mixer. 
 
 
 
Channel Strips 
 
The eight channel strips are virtually identical to each other, with 
the only difference being that channels 1 – 4 are mono and 
channels 5 – 12 are stereo. Each channel strip contains the 
following components. 
 
Fader 
 
The fader controls how much of  the signal from the mic or line 
inputs is sent to the channel. To adjust the level, simply slide the 
fader up and down to the desired level. In the lowest position, 
levels are cut completely, and in the uppermost position you get an 
additional 10dB of  gain. When the fader is at 0, it is at unity gain, 
where the level of  the output equals the level of  the input. 
 
MUTE / Alt 3/4 
 
This switch has two purposes. The mute function is pretty self-
explanatory: when you press the switch, the channel’s output is no 
longer routed to the main mix output. The second purpose of  this 
switch is that in addition to muting a channel, it also routes it to 
the ALT 3/4 OUT found in the patchbay. This is where you get 
the MultiMix’s extra stereo bus. If  you don’t have anything 
connected to the ALT 3/4 OUT, the switch acts only as a mute 
button. If  you do have something connected—say, a multitrack 
recorder—this button acts as a signal router. 
 
PFL / SOLO 
 
The PFL / SOLO switch allows you to single out a channel so you 
can make adjustments to it before you run it into the main mix. 
This is useful for setting an instrument’s gain or EQ and for 
troubleshooting. PFL stands for “pre-fade listen.” In other words