Black Box Black Box SFP Managed Switch Eco Manual De Usuario

724-746-5500 | blackbox.com

Page 19

Chapter 4: Installing the Switch

powered on.

WARNING: When selecting a fiber SFP device, make sure that it can function at a temperature that is not less than the

recommended maximum operational temperature of the product. You must also use an approved Laser SFP
transceiver.

Step 1. Remove and keep the LC port’s rubber plug. When not connected to a fiber cable, replace the rubber plug to protect the
optics.

Step 2. Check that the fiber terminators are clean. You can clean the cable plugs by wiping them gently with a clean tissue or
cotton ball moistened with a little ethanol. Dirty fiber terminators on fiber optic cables will impair the quality of the light
transmitted through the cable and lead to degraded performance on the port.

Step 3. Connect one end of the cable to the LC port on the switch and the other end to the LC port on the other device. Since
LC connectors are keyed, the cable can be attached in only one orientation.

Figure 4-8. Making fiber port connections.

Step 4. As a connection is made, check the Link LED on the switch corresponding to the port to be sure that the connection is
valid.

The fiber optic ports operate at 1 Gbps. The maximum length for fiber optic cable operating at Gigabit speed will depend on the
fiber type as listed in Section 4.12, 1000-Mbps Gigabit Ethernet Collision Domain.

4.10 Connectivity Rules

NOTE: When adding hubs to your network, switches break up the path for connected devices into separate collision domains, so

you don’t include the switch or connected cabling in your calculations for cascade length involving other devices.