Thermador C272 Manual De Usuario

We want you to remain a satisfied customer.  If a problem does come up that cannot be resolved to
your satisfaction write to Thermador Customer Support Call Center, 5551 McFadden Avenue, Hun-
tington Beach CA, 92649 or call: 800/ 735-4328.
Please include the Model Number, Serial Number and Date of Original Purchase/Installation.

Before calling for service, check the following to avoid unnecessary service charges.

All the numbers  touched

The numbers were touched too rapidly.  Be sure you remove your finger from

do not appear in display

the number pad before touching the next digit.

F followed by 2 digits appears

Touch OFF or turn power off at the circuit breaker, wait 3 minutes and turn

in the display window

it back on.  If condition persists, note the code number and call an authorized
servicer.

F-24 or F-25

This is caused by close contact to the control panel for more than 60 seconds,

appears in display window

such as someone leaning against the controls or objects hanging in front of
controls. See item above for correction.

S A b

 appears in display window Turn off the oven selected by touching OFF (single oven model)

 or              (double oven model).

Cooling fan continues to run

The fan turns off automatically when the electronic components have

after oven is turned off.

cooled sufficiently.

Clock and timer

Make sure there is proper electrical power to the oven.

do not work

See the CLOCK and TIMER sections on Pages 10 & 11.

Oven will not work

Make sure there is proper electrical power to the oven.
Check the circuit breaker or fuse box to your house.

Oven light does

Replace or reinsert the light bulb if loose or defective. See Page 33.

not work

Touching the bulb with your fingers may cause the bulb to burn out quickly.
Oven light does not work if CLEAN mode is set.

Oven temperature is

The oven thermostat needs adjustment.  See CALIBRATING OVEN

too hot or too cold

TEMPERATURE in Do-It-Yourself Maintenance, Page 34.

Oven will not self-clean

The oven temperature is too high to set the self-clean operation.
Allow the oven to cool to room temperature and reset the controls.
Be sure you have touched CLEAN.

Oven door will not

Allow the oven to cool below the locking temperature.

unlock

Oven is not clean

Heavily soiled ovens may need to self-clean again or for a longer

after the clean cycle

period of time.  Heavy spillovers should be cleaned before starting
the clean cycle.  See Preparing to Self-Clean, Pages 28 and 29.

Oven does not lock in

Do not run Self Clean. Call for service. See information below.

Self Clean Mode

Page 36