Hoshizaki DCM-751BAH-OS Manual De Usuario

13

1. This icemaker must be installed in accordance with applicable national, state, 

and local codes and regulations.

2. 

CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews 

are securely in place after installation. Make sure that none have fallen into 
the storage bin.

• Visually inspect the exterior of the shipping container and immediately report any

damage to the carrier. Upon opening the container, any concealed damage should also 
be immediately reported to the carrier. 

• Remove the shipping carton, tape, and packing material. If any are left in the icemaker,

it will not work properly.

• Remove the panels to prevent damage when installing the icemaker. See "II.B. How to

Remove Panels."

• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the

sun or to heat, remove the film after the icemaker cools.

• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the

fan blade (if applicable) turns freely.

• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied

corresponds with the voltage specified on the nameplate.

• This icemaker can be installed on a countertop or on an optional stand. If using an

optional stand, Hoshizaki Stand SD-700 or SD-750 is recommended. For further 
options, contact your local Hoshizaki distributor.

• The drip tray on the front of the icemaker is removable for installations using an

in-counter drain. Drip tray removal requires HS-5003 for DCM-751 B_H or HS-5002 for 
DCM-751B_H-OS.