Viewsonic PJ750 Guía Del Usuario

ViewSonic  PJ750

Use a power cable that is properly grounded. Always use an AC power cord that meets your coun-

try’s safety standard.

FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.

IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET THEN THE 

PLUG SHOULD BE CUT OFF AND DISPOSED OF SAFELY.

THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS 

INSERTED INTO AN APPROPRIATE SOCKET.

If a new plug is to be fitted, please observe the wiring code as shown below.

If in any doubt, please consult a qualified electrician.

WARNING: THIS APPLIANCE MUST BE EARTHED.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: 

Green-and-Yellow: Earth

Blue: Neutral

Brown: Live

If the coloured wires of the mains lead of this appliance do not correspond with the coloured mark-

ings identifying the terminals in your plug, proceed as follows:

The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug 

which is marked by the letter E or by the Earth symbol or coloured GREEN or GREEN-AND-YEL-

LOW.

The wire which is coloured BLUE must be connected to the terminal in the plug which is marked 

with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to 

the terminal in the plug which is marked with the letter L or coloured RED.

IMPORTANT NOTICE CONCERNING POWER CORD SELECTION

The power cord set for this unit has been enclosed and has been selected according to the country of 

destination and must be used to prevent electric shock. Use the following guidelines if it is necessary 

to replace the original cord set, or if the cord set is not enclosed. 

The female receptacle of the cord set must meet CEE-22 requirements and may look like (Figure A1 

below):

In the United States and Canada the male plug is a NEMA5-15 style (Figure A2), UL Listed, and 

CSA Labeled. For units which are mounted on a desk or table, type SVT or SJT cord sets may be 

used. For units which sit on the floor, only SJT type cord sets may be used. The cord set must be 

UL

CSA

VDE

SEV

BASE/BS

Electric Appliance Control Act