Garmin 200 Guía Del Usuario

Appendix

A carabiner with a clip comes with 

the Oregon 300 and 400 series units 

and is optional with 200 series units.

1.  Position the carabiner clip in the 

slots on the mounting spine of the 

Oregon.

2.  Slide the clip up until it locks in 

place.

To remove the carabiner clip, lift 

the bottom of the clip and slide the 

carabiner clip off the mounting spine.

The Oregon screen does not 

normally require calibration. 

However, if the buttons do not seem 

to be responding properly, use the 

following process.

1.  While the unit is turned off, press 

and hold the   

 key for 

approximately 30 seconds.

2.  Follow the instructions on the 

screen until “Calibration is 

complete” is displayed.