Maytag M1TXEGMYS Guía Del Usuario
10
On models with notches:
■
Slide the indicator down into the notches, facing outward.
NOTE: The indicator will not easily slide into the notches
if the rear bubble has not been popped.
if the rear bubble has not been popped.
■
Close the air filter door, and check that the indicator is
visible through the rectangular hole in the door.
visible through the rectangular hole in the door.
On models without notches:
■
Store the indicator in a visible place you will easily
remember - either inside the refrigerator, or elsewhere in
your kitchen or home.
remember - either inside the refrigerator, or elsewhere in
your kitchen or home.
Style 2 - Air Filter Status on Electronic Control Display
The control panel displays the Air Filter status.
■
GOOD - The air filter LED does not light up.
■
REPLACE - The air filter LED lights up constantly when the
refrigerator door is open.
refrigerator door is open.
■
EXPIRED - The air filter LED lights up constantly and flashes
when the refrigerator door is open.
when the refrigerator door is open.
After replacing the air filter, press and hold FILTERS RESET for
3 seconds. The filter icons will turn off. See “Using the
Control(s).”
3 seconds. The filter icons will turn off. See “Using the
Control(s).”
NOTE: At any filter status, pressing and holding FILTERS RESET
for 3 seconds will reset the air filter status to good and the air
filter LED will turn off.
for 3 seconds will reset the air filter status to good and the air
filter LED will turn off.
Replacing the Air Filter
The disposable air filter should be replaced every 6 months, or
when the status indicator air filter icon LED turns on and starts
flashing when the refrigerator door is opened.
when the status indicator air filter icon LED turns on and starts
flashing when the refrigerator door is opened.
To order a replacement air filter, contact us using the
assistance/service information following the warranty.
assistance/service information following the warranty.
1. Remove the old air filter by squeezing in on the side tabs.
2. Remove the old status indicator.
3. Install the new air filter and reset the status indicator using
the instructions in the previous sections.
REFRIGERATOR USE
Using the Controls
The temperature controls are located at the top front of the
refrigerator or freezer compartments.
refrigerator or freezer compartments.
Temperature Controls
For your convenience, the temperature controls are preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended setting as shown.
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended setting as shown.
Style 1
Recommended Setting
Style 2
Recommended Setting
Style 3
Recommended Setting “3 Snowflakes”
IMPORTANT:
■
The recommended setting should be correct for normal
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream
is firm.
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream
is firm.
■
Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.
controls to a colder than recommended setting will not cool
the compartments any faster.
■
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
To Turn Cooling Off/On:
Styles 1 and 2 - Press and hold TEMP for 3 seconds to turn
cooling off. To turn cooling back on, press and hold TEMP again
for 3 seconds.
cooling off. To turn cooling back on, press and hold TEMP again
for 3 seconds.
Style 3 - Move the dial control to the word OFF. To turn cooling
back on, move the dial control to the desired temperature setting.
back on, move the dial control to the desired temperature setting.
NOTE: Neither compartment will cool when the control is set to
OFF.
OFF.
Adjusting Controls
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart below as
a guide.
freezer compartment, use the settings listed in the chart below as
a guide.
Styles 1 and 2 - Electronic Controls
■
Press the TEMP button to toggle among the four LED lights
which indicate the temperature setting. Reading from left to
right, the LED in the first position is the least cold. The LEDs
indicate increasingly colder settings as you continue to the
right until all four LEDs are illuminated.
which indicate the temperature setting. Reading from left to
right, the LED in the first position is the least cold. The LEDs
indicate increasingly colder settings as you continue to the
right until all four LEDs are illuminated.
NOTE: For the first to fourth setting, only one LED of the four
LEDs will be lit. All four LEDs will be lit when you have
reached the coldest setting.
LEDs will be lit. All four LEDs will be lit when you have
reached the coldest setting.
Style 3 - Dial Control
■
Move the dial to the desired number of snowflakes from
(1 least cold to 5 coldest).
(1 least cold to 5 coldest).