Bosch ltc-0335-28 Instruccion De Instalación
Bosch Video Management System
Encoders / Decoders page | en
123
Bosch Sicherheitssysteme GmbH
Configuration Manual
Configuration Client | V3 | 2010.07
Automatic IP assignment DHCP
Allows you to activate the automatic acceptance of DHCP server assigned addresses. Select
On to activate this function.
Subnet mask:
Type the subnet mask number of the device obtained from your network administrator.
Gateway address
Type the IP address for the gateway to connect the device to a remote location in a different
subnet. Otherwise, this box can remain empty (0.0.0.0).
DNS server address
Type the IP address of the DNS server for this device.
Units listed on a DNS server are easier to access. To establish an Internet connection to the
device, it is sufficient to enter the name of the device - used in the DNS server - as URL in the
browser. Secure and dynamic DNS servers are supported.
Video transmission
Select TCP as protocol for units used behind firewalls. Select UDP for units used in a local
network.
Note:
–
UDP supports multicast. TCP does not. The Maximum Transmission Unit (MTU) value in
UDP mode is 1514 bytes.
–
Bosch VMS NVR only supports UDP.
HTTP browser port
Select the HTTP browser port from the list. The default port is 80. To limit connection to
HTTPS, deactivate the HTTP port. To do this, select Off.
HTTPS browser port
Not supported.
RCP+ port 1756
Select On to allow unencrypted connections on this port. Select Off to allow only encrypted
connections (not supported).
Telnet support
Select On to allow unencrypted connections on this port. Select Off to allow only encrypted
connections (not supported).
Interface mode ETH 1 / Interface mode ETH 2
If necessary select the value for the interface, e.g. 100 Mbps HD. This value is device
dependent and must be set individually.
Network MSS (Byte)
Enter the maximum segment size (MSS) of the IP packets.
This setting allows you to adjust the size of the data packets to the network environment and
to optimize data transmission. Observe the MTU value of 1514 bytes in UDP mode.
iSCSI MSS (Byte)
Enter the Maximum Segment Size (MSS) for a connection to the iSCSI system.
CAUTION!
Be careful with enabling the automatic IP assignment. This can make the device unreachable.