Sanyo PLC-WTC500L Manual De Usuario

When the total lighting time of a Projection Lamp 

reaches the recommended total hours of use, the Lamp 

replacement icon appears on the screen and LAMP 1 / 2 

REPLACE indicator lights yellow. Replace the lamp with 

a new one promptly. The timing when the LAMP 1 / 2 

REPLACE indicator should light is depending on the lamp 

mode.

Follow these steps to replace the lamp.

For continued safety, replace with a lamp of the same 

type lamp. Do not drop the lamp or touch the glass 

bulb! The glass can shatter and may cause injury.

Allow a projector to cool for at least 45 minutes 

before you open the Lamp cover. The inside of 

the projector can become very hot.

Turn off the projector and unplug the AC power cord. 

Let the projector cool for at least 45 minutes.

Lift the lamp out of the projector by using the handle.

Replace the lamp with a new one. Make sure that 

the lamp is set properly. Put the lamp cover back and 

secure it with the screw.

Remove the screw that secures the lamp cover with a 

coin, and then open the lamp cover.

Screw

Lamp replacement icon

Lamp cover

✔

Check the number of lamp to be replaced on the Lamp 

Status Display or the LAMP 1/2 REPLACE indicators 

and replace the lamp.

Handle

Lamp 1

Lamp 2

 When replacing the lamp because it has stopped 

illuminating, there is a possibility that the lamp maybe 

broken. If replacing the lamp of a projector which has 

been installed on the ceiling, you should always assume 

that the lamp is broken, and you should stand to the side 

of the lamp cover, not underneath it. Remove the lamp 

cover gently. Small pieces of glass may fall out when 

the lamp cover is opened. If pieces of glass get into your 

eyes or mouth, seek medical advice immediately.

✔