TallyGenicom LA48N Guía Del Usuario

Printing

4-8

Before you start to print, make sure that paper is loaded. Also, verify that the paper 
thickness lever is set to the appropriate position (1 to D).

To start printing, make sure that the Ready indicator is lit (the printer is ready). If not 
so, press the Pause button to place the printer in the Ready state. Then start your soft-
ware.

To stop printing, press the Pause button to place the printer in the Pause state. The 
printer stops after printing the current and next lines. You can also use your software 
to stop printing, but there will be a slight delay before printing stops. After the printer 
enters the Pause state, it still receives data until the print buffer becomes full of new 
data. The data in the print buffer will be lost if you turn the printer off.

When the printer stops printing, the paper is advanced to the viewing position so that 
you can view the last printed lines. This function is valid for single sheets and con-
tinuous forms in push-tractor feed mode but not valid for continuous forms in pull-
tractor feed mode.

To resume printing, press the Pause button again. If the paper is advanced for view-
ing, it is backed to the previous position before printing. To cancel printing, use the 
cancel commands provided by your software or computer. To clear the print buffer, 
turn the printer off. Any data sent to the print buffer before you canceled printing will 
be lost.

The printer can “sense” when paper runs out. The printer stops printing and lights the 
Fault indicator.  To resume printing when paper runs out, follow the procedures de-
scribed below:

Install paper on the forms tractor unit or on the cut sheet stand as described in 
Chapter 2, “Setting up the printer”.

To load the first sheet of paper, press the FF/LOAD button for continuous forms. 
Single sheets are automatically loaded unless you change the factory setting. The 
Fault indicator will turn off and the printer resumes printing.