Linksys BEFN2PS4 Instruccion De Instalación

This sheet will guide you through the basic steps needed to install the
EtherFast Cable/DSL & Voice Router onto your network. If you have
any problems during installation, refer to the Troubleshooting section
of the User Guide.

Pr

Pr

eliminary Information

eliminary Information

• Your broadband-configured PC’s fixed Internet IP Address

• Your broadband-configured PC’s Computer and Workgroup

Names

• Your Subnet Mask

• Your Default Gateway 

• Your ISP’s DNS IP Address

Installing Y

Installing Y

our EtherFast

our EtherFast

Cable/DSL & V

Cable/DSL & V

oice

oice

Router Onto

Router Onto

Y

Y

our Network

our Network

1.  Power everything down, including your PCs, cable or

DSL modem, and the Router. 

2.  Connect a network cable from one of your PCs’ Ethernet

ports to one of the LAN Ports on the back of the Router.
Do the same with all the PCs you wish to connect to the
Router. (LAN Port 4 will become inactive if you use the
Uplink port.)

3.  Connect the network cable from your broadband modem

to the WAN port on the rear of the Router. 

4.  Connect the power-supply cable to the Power port on the

rear of the router, then connect to a power outlet using the
power cord included in the router’s packaging.

• The Power LED will illuminate green as soon as the

power adapter is connected.

• The Diag LED will illuminate red for a few seconds

while the Router goes through its internal diagnostic test.
The LED will turn off when the self-test is complete.

5. Power on one of your PCs and login if you are asked to.

When you reach the desktop, click the Start button, select
Settings, then select Control Panel.

6. Double-click the Network icon.

7. In 

the 

Configuration window,

highlight the TCP/IP that has
been associated with your net-
work card or adapter. (Do NOT
configure TCP/IP->Dial-up
Adapter.) Click Properties. If
the TCP/IP Protocol isn’t listed
in the Configuration window,
refer to the User Guide now.

8. Click the IP Address tab. Select Obtain an IP address auto-

matically. Click OK.

9. Click OK again. Windows may begin copying files to your

computer, and then will ask you to restart your PC. Click
Yes to restart your computer and initiate the new settings. If
you aren’t asked, manually restart the computer.

Model No.: BEFN2PS4

EtherFast Cable/DSL &

Voice Router

N

No

otte

e: Steps 6-9 will only

work in Windows 95 ,98 or
Millennium. If you are using
Windows NT or 2000,
please check your
Windows NT or 2000  doc-
umentation to configure
your TCP/IP protocol.

QI-BEFN2P4S-01219NC DG