Bosch ra1171 router table Manual De Usuario

1. If the fence is already installed on the table, remove it

before proceeding.

2. Place the router mounting plate (3) in the opening so

the numbers on the scales are right side up, as seen
from the front of the table. Using a straight edge,
check to be certain that the surface of the router
mounting plate is flush with the tabletop surface. 
NOTE: Failure to make sure the router mounting
plate is flush with the tabletop surface can result in
poor routing performance. Slide a square cut board
from right to left across the router mounting plate to
be sure that it moves smoothly.

3. To adjust the plate, insert the 6mm hex key through

the outermost corner holes in the mounting plate 
and turn the leveling inserts clockwise to lower the
mounting plate or counterclockwise to raise the 
mounting plate.

The router adapter plate features an access hole to
allow use with the over-table height adjustment feature
on the Bosch 1617 series routers. Refer to your router
manual for additional information on using this feature.

For the Porter Cable 892 and 895 and the Milwaukee
5615 and 5616 model routers, it is necessary to drill 
an access hole to accommodate the over-table height
adjustment:

1. Remove the subbase from the router and align 

the mounting holes in the subbase with the 
corresponding mounting holes in the adapter plate.
Be sure to orient the subbase so that the router
switch will be toward the front of the table.

4. Secure the router mounting plate (3) to the table 

with four #10-32 x 1/2

″ pan-head machine screws

(33) (Fig. 13) through the outermost corner holes in
the plate. Tighten the screws snugly, but do not 
overtighten.

2. Using a pencil or centerpunch, mark the location of

the over-table height adjustment hole on the router
adapter plate.

3. Remove the subbase from the adapter plate and

carefully drill the over-table height adjustment hole. 

4. Make sure that the hole will accommodate the height

adjustment tool for your router. Remove any burrs or
rough edges with sandpaper.

To remove the router from the mounting plate, you 
must first remove the router mounting plate from the
router table. 

plugged into a power outlet when installing into the
table, removing from table, making adjustments or
changing accessories. Router could accidentally start.

1. Loosen the four #10-32 x 1/2

″ pan-head Phillips

machine screws (33) holding the router mounting
plate to the tabletop. 

2. Lift the router mounting plate and router upwards

from the tabletop.

3. Remove the countersunk machine screws securing

the router to the mounting plate.

4. When reinstalling the router mounting plate, be sure

that the plate is level with the tabletop. If needed,
readjust as described above.