Bosch ra1171 router table Manual De Usuario

NOTE: The top/front side of each featherboard is
marked to indicate proper feed direction.

1. Insert two 1/4-20 x 1

1

⁄

2

″ carriage bolts (40) 

through the slotted holes in the featherboard (24).
See Fig. 18. 

2. Slide a large washer (31) onto each carriage bolt and

thread a small clamping knob (22) three or four turns
onto each carriage bolt. 

3. To install on the fence, slide a spacer (21) over the

head of each carriage bolt, aligning the tabs on the
spacer with the slot in the featherboard (Fig. 19).
Then slide the carriage bolt heads into the T-slot 
on the top of the fence.

4. Secure the featherboard assembly by tightening the

knobs, making sure that the tabs on the spacer are 
in the slot on the fence. 

NOTE: The featherboard slide plate assembly is 
T-shaped for use in the miter channel and has round
indentations on the bottom for the carriage bolt heads. 

1. Insert two 1/4-20 x 1

1

⁄

2

″ carriage bolts (40) through

the holes in both the lower (25A) and upper (25B)
featherboard slide plate and the slotted holes in the
featherboard (24) as shown in Fig. 20.

2. Slide a large washer (31) onto each carriage bolt and

thread a small clamping knob (22) three or four turns
onto each carriage bolt.

3. To install the featherboard in the miter channel, insert

the featherboard slide plate into the miter channel.
Then slide the featherboard to the desired location 
on the miter channel and tighten the clamping knobs.