Bosch ra1171 router table Manual De Usuario

1. Select a board that is smooth and straight, with good

square edges.

2. Mark lines “A” and “B” on the end of the board, as

shown in Detail 23.

• Line “A” indicates the desired height of cut.

• Line “B” indicates the desired final depth of cut.

• The area outlined by “A,” “B” and the edge of the

board is the area that will be cut away.

3. If the desired depth of cut can be cut in a single 

pass, loosen the fence clamping knobs and move the
fence forward or backward until the outermost cutting
edge of the router bit is aligned with line “B”. It may
be necessary to reposition the guard to provide 
clear access.

NOTE: For deeper cuts, do NOT attempt to make 
the cut in a single pass. Make multiple shallower cuts
passes, progressively moving the fence backward
until the desired depth of cut is reached.

4. Use the scales on the table top as a guide to align

the fence; then SECURELY tighten both fence 
clamping knobs.

5. Following the instructions that came with your router,

adjust the router height of cut until the top of the
router bit lines up with line “A.”

6. Once all adjustments have been made, double-check

that:

• The router is SECURELY tightened in the 

router base.

• The router bit is SECURELY tightened in the router

collet, with at least 3/4

″ shank engagement.

• The router base is SECURELY tightened to the

router mounting plate.

7. Remove the board from the table. 

NOTE: When making adjustments, use a piece of
scrap wood to make trial cuts before making the cut
with the actual workpiece.