Clark Synthesis TA0.1 Instruccion De Instalación

www.clarksynthesis.com

The TA0.1 can be custom mounted for use in a variety of applications. 

By utilizing the pre-drilled holes in the mounting plate and the Remote 

Control, the installer can mount the amplifier to almost any surface 

that provides 1) access to the Remote Control, 2) access to the 

Input/Output Panel and the AC Panel, 3) adequate ventilation for the 

amplifier, and 4) the ability to remove the amplifier or the Remote 

Control for servicing should that become necessary.

CAUTION: Insure there are two (2) inches of clearance 

around the amplifier. 

DO NOT block the air vents. The 

amplifier will overheat if it does not have adequate ventilation.

The following steps describe the process for mounting the TA0.1 

amplifier:

Determine where you want to mount/place the Remote Control.

1. 

Determine where you want to mount/place the amplifier.

2. 

Holding the Remote Control in the position you determined in 

3. 

#1, extend the wire from the Remote Control to the amplifier’s 

prospective location to determine if it can reach the amplifier 

without being overstretched or pinched in any way. If the wire 

cannot reach, or will be overstretched/pinched, adjustments will 

need to be made to the mounting location(s).

Once an adequate location for the Remote Control and the 

4. 

amplifier is found, attach the remote control using the pre-drilled 

holes in the corners of the box (see below). To avoid damaging 

the box, use 5/8 inch or M8 flat washers.

Attach the amplifier to the mounting surface using the holes in 

5. 

the mounting plate (see below).

Connect the wire from the Remote Control to the amplifier.

6. 

CAUTION: When mounting in furniture, it is important to 

insure the wires going to and from the amplifier, including 

the wire from the Remote Control, will not be pinched or cut 

by hardware moving within the chair, e.g., footrest arms, 

recliner assemblies, etc.

NOTE: It is very important that the amplifier and the 

Remote Control be installed in such a way that either 

unit can be removed should servicing or replacement be 

required.