Conairphone cid100 Guía Del Usuario

If area code is set, the LCD shows
‘ENTER TIME DATE’.
Press [ ] or [ ] to select the hour digits.
Press [ERASE] to confirm and go to the
next entry.

Press [ ] or [ ] to select the minute
digits.
Press [ERASE] to confirm and go to
the next entry.

Press [ ] or [ ] to select the month
digits.
Press [ERASE] to confirm and go to
the next entry.

Press [ ] or [ ] to select the date
digits.
Press [ERASE] to confirm.

The LCD shows ‘TOTAL:00  NEW:00’,
which means both the total call and
new call counter are zero.

1. Plug the long telephone line cord into the jack in the bottom

of the BASE, thread it through the groove toward the back of
the unit, then plug it into the modular phone jack.

2. Connect the COIL CORD to the jack in the HANDSET and

the BASE.

When the CID100 is wall mounted, the HANDSET GUIDE holds
the handset in place in the cradle.

1. Plug the short telephone line cord

into the jack in the base bottom and
into the jack on the plate.

2. Hang the base on to the two pins

and pull the base down to lock it
on.

3. Plug the coil cord into the handset

and base jacks.

1. Install 2 screws with anchors into

the wall, one above the other, 3-1/
4" apart, extending 3/16" out from
the wall to hold the base securely.

2. Install the long telephone line cord

into the jack in the base, thread it
through the groove and plug it into
modular wall jack as shown.

3. Hang the base on the screws and

pull it down to lock it on.

4. Plug the coil cord into the handset

and base jacks.

Set switch to your type of service. If you don’t know whether you
have tone or pulse:
1. Put the switch on “TONE”.
2. When you have a dial tone, press any key on the keypad. If

the dial tone stops, leave it on “TONE”. If not, change the
setting to “PULSE”.

The receiver volume control is located on the side of the handset
of your phone. This enables you to adjust the receiver volume
from NORM to HI for a better listening level.

Your CID100 features a harmonic dual tone ringer that can be
adjusted from a loud (HI) to a soft (LO) sound level. When you
don’t want to be disturbed, slide the switch to the OFF position.
You can still make outgoing calls without being disturbed by
incoming calls.

Whether you have Tone or Pulse service, you can insert a 4-
second PAUSE into the dialing or storing of a number into
memory in order to access custom and telebanking services,
long distance, etc. Press [REDIAL] at the desired point in the
number. Press [REDIAL] again if an additional 4 seconds is
needed.

Automatically redials last number called (up to 32 digits). If the
number was busy or unanswered:
1. Lift the HANDSET.
2. Press [REDIAL].

NOTE: Batteries must be installed, or Telephone operations will
not work properly (see Installation).

1. When your phone rings, pick up the handset and use it like

any basic telephone.

2. Hang up the handset to release the telephone line when your

conversation is completed.

1. Pick up the phone and wait for a dial tone.
2. Press the keypad for the telephone number you wish to dial.

7

8

9